Show Identified Peaks
IR and RAMAN interpretation strongly depends on peak detection, which is done prior to analysis. In order to see the identified peaks you may activate peak markers in the spectrum view of the spectrum analysis result. When activated, the peak position is indicated by a vertical red line.
For details please refer to the chapter "Peaks" in section "Data View Enhancements".
Sometimes it might be necessary to modify peak detection parameters, because automatic peak detection does not produce satisfactory results. You have the following options to take influence on peak detection:
Open the Preferences dialog and change "peak detection" settings there. Please refer to the section "Preferences" for details.
Before you analyze a spectrum, perform manual peak detection using the Find Peaks function in the Mathematics menu of the software.Analysis only considers your personal set of detected peaks then.
You may also like to review all identified peaks. They can be colorized in the spectrum to reveal not yet analyzed areas. Please refer to the chapter "Highlight all assigned Functional Groups" for details.